How to insert/remove terminal battery

Viking, OnePA and PSAM terminal

1. Turn the terminal upside down and open the battery cover.

2. Lift up the battery.

3. Disconnect the connector in the middle of the wires from the battery to the terminal.

4. Connect a new battery.

5. Close the battery cover.

Castles

Do not remove the battery to avoid damage in the battery and hardware.

Nets SmartPOS N950 terminal

1. Turn the terminal upside down and open the battery cover.

2. Insert the battery plug into the socket and insert the battery into the battery compartment.

3. Once the battery is installed, press the battery cable to make the cable lower than the battery.

4. Close the battery cover.

Note! Make sure that the terminal is switched off and that the adapter is disconnected before installing the battery. Always use the original battery and power adapter provided by Nets. Using alternative batteries or adapters from different devices or providers may cause damage, heating, or even explosion in the hardware and battery. Charge the terminal under the conditions described in this document.